Author Topic: Indicator dash light not working  (Read 120 times)

Tzr3ma

  • Jr. Member
  • **
  • Location: Middlesex
  • Posts: 27
Indicator dash light not working
« on: May 16, 2018, 06:22:52 PM »
Indicator dash light not working when indicators flashing on right side any ideas
Thanks

jcsnook

  • Hero Member
  • *****
  • Location: Tampa Bay, Florida
  • Posts: 1155
Re: Indicator dash light not working
« Reply #1 on: May 16, 2018, 09:54:11 PM »
Bulb in the dash is burnt out?
If your not mixing gas, your not hauling ass!

Tzr3ma

  • Jr. Member
  • **
  • Location: Middlesex
  • Posts: 27
Re: Indicator dash light not working
« Reply #2 on: May 17, 2018, 08:31:13 AM »
Sorry should have put it works fine when left indicator on

jcsnook

  • Hero Member
  • *****
  • Location: Tampa Bay, Florida
  • Posts: 1155
Re: Indicator dash light not working
« Reply #3 on: May 17, 2018, 04:06:02 PM »
Have you tried swapping the left/right indicators around to see if the problem moves?  A long shot, but at least you'd rule out the indicator.
If your not mixing gas, your not hauling ass!

ColinS5940

  • Jr. Member
  • **
  • Location: Devon
  • Posts: 72
Re: Indicator dash light not working
« Reply #4 on: May 17, 2018, 07:00:20 PM »
Have you got an led bulb in the dash? If so, it'll only work one way

Tzr3ma

  • Jr. Member
  • **
  • Location: Middlesex
  • Posts: 27
Re: Indicator dash light not working
« Reply #5 on: May 17, 2018, 09:16:45 PM »
Yes I have got a led bulb I will change it
Thanks

ColinS5940

  • Jr. Member
  • **
  • Location: Devon
  • Posts: 72
Re: Indicator dash light not working
« Reply #6 on: May 17, 2018, 09:24:27 PM »
👍

tzr-v4

  • Hero Member
  • *****
  • Location: France
  • Posts: 1290
  • South West of France
    • French RD500LC Club
Re: Indicator dash light not working
« Reply #7 on: May 18, 2018, 12:37:50 PM »
Typical Yahama turn signal wiring.

When flashing left hand, the current is passing in the indicator one way and when flashing right hand then the current goes the other way in the indicator.

If you want to use led bulb or standard led then you need a diode bridge like this
https://www.taydaelectronics.com/diodes/dbl104g-c1-single-phase-diode-bridge-rectifier-400v-1a-db.html
Olivier.
TZR250 2MA & 2XT, RD500s et TZR-V4 building...

Tzr3ma

  • Jr. Member
  • **
  • Location: Middlesex
  • Posts: 27
Re: Indicator dash light not working
« Reply #8 on: May 21, 2018, 09:48:17 AM »
 Thanks