Author Topic: Ignitech settings  (Read 205 times)

Noisy Cricket

  • Jr. Member
  • **
  • Posts: 30
Ignitech settings
« on: June 13, 2018, 09:44:42 PM »
I have been struggling to set up the Ignitech on my TDR. I requested that Jiri send me the ignition with the stock settings as would be appropriate. The ignition curve did not much factory nor did the PV programming. The engine starts right up, but I cannot get it to match a 10 degree flat curve. The version of the software they send me is: 140620b_Dccdip2_race_v86.exe. I bought two of these ignitions (one also for my TZR). I am happy to PayPal you $100.US if you could just send me an .ign file that works and is compatible with the software Jiri sent me. If the file is not compatible with v86. Clue me as to which software I need to download from the Ignitech site to be compatible with your .ign file. If its not too much trouble could you email me direct? Jim - jpcomrie@gmail.com otherwise PM me here. Its just really frustrating because in all other ways my TDR400 is ready to go....

rdlclazy

  • Jr. Member
  • **
  • Posts: 44
Re: Ignitech settings
« Reply #1 on: July 22, 2018, 07:41:52 PM »
If you know a good dyno operator then they can write a map for the bike