Hello,
Does anyone have a machine shop in this group ? ( I try to find before ask the question )
Thanks ^-^
What is it you are looking to create please?
This one
Assembly on the pictures
ASSY1.png ASSY2.pngASSY3.pngASSY4.pngASSY5.png
Triple tree & handle bar for my TZR with RSV1100V4 fork
Thanks
Aluminium 6061 T6 ....I'm charge of the anododizing
You sure about 6061? I made some clamps for my R6 earlier this year. Granted, I gave my setup some very conservative inputs (IE the clamp is holding the full weight of the bike, as if I was riding and forgot to tighten the other clamp), but I was not very comfortable with the safety margin for 6061, yield strength ~276 MPa and this setup was at 200 MPa in a couple spots. Even adjusting the model to remove the obvious stress concentrations I was still ~160 MPa peak, ended up going with 7075 instead. It's a track bike, after all, probably gonna end up crashing it eventually.
I Gooch
I choose the 6061 T6 alloy for three reasons:
-The first one is 7075 alloy is hard to anodize because the % of cooper
-The second is....I'm an old guy wich ride relax ;D
-The last one is,I prefer that triple tree brok in case of knock ans either a king of breaker for the frame.
Thanks a lot for your very interesting feedback