Who deserves a xmas present ? TZ 360 cyls & heads for 3XV

[peterbike]

I bought these 2 years ago, when I was riding my 3XVR.  Since then I have gotten my  3XV SP going and have decided that I don't need to go any faster. (i think I'm too old. the SP is fast enough)
They were made by Hans Hummel as a TZ 360 kit. They are a 66.25 bore, they come with mahle pistons which are about 6mm taller from the piston pin to crown , so they run a spacer under the cylinder.
I have discovered since that the mahle pistons are no longer available, but then found that  DT 175/220?
pistons will work ( can't remember which)  If you run the DT pistons no cylinder spacers would be needed.

There reed valve spacers.
  You would need to open up the cylinder holes in the upper crank case.
There are no EPV's. although it looks as tho the casting was made with barrel style PV's in mind, but were never fitted.
They have been used , but look in good condition.  The guy I bought them off said they made 90 hp, but can be made to produce 120 hp.  ( true or not ?)
I paid $2500 aust for them, so that is what they will be offered for.
$2500
Peter

[eyrey1]

i like those !
someone buy them !
i want to know what difference they make
like a athena kit for 3xv  lol

[Paul]

That's some serious dough.
Would make a nice Xmas present I agree.

[scooble]

that would SERIOUSLY piss off the 4bangers in the Bemsee F400 class ...he he he

[Neal]

I have a enough curiosity to buy them !
Pm on the way

[eyrey1]

hope they do what it says on the packet neal 
should be a right laugh